Keep the interior cool when it’s hot is a problem. The sun beats down on your home page internal temperature rises to uncomfortable levels. Air conditioning provides some relief. But to run the initial cost of installing air conditioning and electricity costs, it can be high.

In addition, conventional air conditioners use refrigerants with chlorine compounds, suspected contributors to ozone depletion and global warming. But there are alternatives to air conditioning air. This article provides suggestions of common sense and low cost of the modernization options to help you “Stay cool and save electricity.

Staying Cool

The most effective method to cool your home to heat from the building primarily for hold. The main source of heat (ie profit) the sunlight is absorbed by your house through the roof, walls and windows. Secondary sources are heat-generating devices in the home of aviation and air. Specific methods to prevent heat recovery are reflective heat (eg sunlight) of your house, blocking the heat, heat remove built, reduce and or eliminate sources of heat in your home.

Given the Heat

absorb Dull and exterior, dark 70% to 90% in the form of radiant energy from the sun strikes the surfaces of the home. Some of this absorbed energy is then transferred into your home through cable, which provide heat. In contrast, light-colored surfaces effectively most of the heat reflected away from your house. The most effective method to your home is cool to keep heat from the building in the first.

Installing a radiant barrier

Radiant barriers are easy to install. It does not matter how shiny surface faces – up or down instead of horizontally across the ceiling -… but you have to install it on the underside of the roof and the barrier must be an airspace

For your comfort while in the attic, install the radiant barrier in a cool, overcast day, use plywood walking boards or planks on the ceiling beams to help Note:.. Do not walk between the ceiling joists, you can fall through the ceiling Staple drape the paper down or side of the rafters them from rafters. to rafters. Do’s no worries about fit or small tears in the fabric, the transfer by radiation is not affected by air movement. Staples should not exceed 2 to 3 inches (5-8 cm) apart, the air supply and release or release prevent the radiant barrier. use builds up a caulking gun, apply a thin bead of adhesive to the rafters along the seams of the barrier film. This makes the installation permanent.

Roofs

About a third of the unwanted heat that in your house is through the roof. It is difficult with traditional roofing materials control. For example, unlike most light colored surfaces absorb even the asphalt fiberglass shingles white and 70% of solar radiation. A good solution is to create a reflective coating to your existing roof apply. Two standard roofing coatings are available from your local hardware store or timber. Both water resistance and reflection, and are marketed primarily for mobile homes and recreational vehicles. A coating is white latex that many common roofing materials such as asphalt shingles and fiberglass, tar paper and metal are valid. Most manufacturers offer a warranty of 5 years.

A second layer is asphalt and contains glass fibers and aluminum particles. you can use it on most metal roofs and asphalt apply. Because it is a has sticky surface that attracts dust, which reduced his thoughts a little. Another way to reflect heat to install a radiant barrier on the underside of the roof. A radiant barrier is simply an aluminum foil with a paper backing. If they are installed correctly is, a radiant barrier to reduce heat gains through your ceiling by about 25%. (See information on installing a radiant barrier.) Radiant-barrier materials cost between 0.13 per square foot (0.44 square meters) for a single Layer product with a kraft paper backing and 0.30 per square foot (0.33 square meters per air) reinforced for a vented multiflora product with a support. The latter product acts as insulation.


Mobile Home Warranty